Blog · Grading & Authentication
How to Check Pokémon Card Centering Before Grading (2026)
By Dexhaul Team · November 6, 2026 · 7 min read
Centering fails more PSA 10 submissions than surface scratches. A card can miss Gem Mint by under half a millimeter, and you will not know unless you measure before you pay submission fees.
Three checks done in order will tell you whether a card is worth submitting for PSA 10 or whether a lower grade tier is a more realistic target. This guide covers how to check Pokémon card centering at home, what each grade requires, and the one back-centering rule most collectors miss entirely.
The three fastest checks for Pokémon card centering
Check 1: the visual tilt test
Hold the card at arm's length under even lighting with the front facing you. Tilt it slowly left and right. A severely off-center card will show one border noticeably wider than the opposite side before any measuring tool is needed.
This is a disqualification filter only: a card that passes the tilt test may still fail the ruler check.
Flip the card and repeat. The back is graded on a much more lenient standard (see the centering table below), so obvious skew on the back is a warning but not an automatic disqualification except at PSA 10.
Check 2: measure both axes with a ruler or digital caliper
Lay the card face-up on a clean surface. Measure the left border and the right border in millimeters. Write both numbers down.
Then measure the top border and the bottom border. You need all four figures.
Calculate each axis as a ratio: divide the wider border measurement by the sum of both borders on that axis, then express as a percentage. If your left border is 3.8 mm and your right is 3.2 mm, the ratio is 3.8 ÷ 7.0 = 54.3% / 45.7%, which rounds to 54/46.
That passes PSA 10. If the same axis reads 4.4 mm vs 2.6 mm, it is 62.9% / 37.1%, which does not.
A digital caliper (accurate to 0.01 mm) gives a more reliable result than a standard ruler, especially on modern Scarlet and Violet era cards where borders are narrow.
Measure the back independently. PSA grades front and back centering separately. A card can have excellent front centering and still drop to PSA 9 if the back misses the PSA 10 back threshold.
DexHaul's free Pokémon card centering checker offers a photo-based alternative to ruler measurement. Upload a photo and it measures centering, zooms into corners and edges, and estimates whether the card is likely to reach a given PSA, BGS, CGC, or TAG grade and whether the submission cost is worth it.
Check 3: compare against the published grade thresholds
Use the ratios from Check 2 against the thresholds published by PSA on their grading standards page:
| PSA Grade | Label | Front centering | Back centering |
|---|---|---|---|
| 10 | Gem Mint | 55/45 or better | 75/25 or better |
| 9 | Mint | 60/40 or better | 90/10 or better |
| 8 | Near Mint–Mint | 65/35 or better | 90/10 or better |
| 7 | Near Mint | 70/30 or better | 90/10 or better |
The back centering threshold jumps sharply from 75/25 for PSA 10 to 90/10 for PSA 9. That means back centering almost never disqualifies a card from a PSA 9 or lower result. Front centering is what you are really pre-screening.
CGC uses comparable centering thresholds across their own grading scale; check their current standards page before submitting to CGC specifically.
On this page 7 sections
What you need
The minimum kit: a penny sleeve (to handle the card without touching the surface), a toploader (to lay it flat and stable), and a ruler or digital caliper. Good overhead lighting or a lightbox helps visibility on modern holofoil cards, where the foil layer can make border edges harder to read.
A digital caliper measuring to 0.01 mm costs under $15 at most hardware stores and pays for itself after one avoided failed submission. Standard plastic rulers are acceptable for pre-screening but can introduce 0.5 mm read error from parallax.
Use 35pt toploaders for standard Pokémon cards (Base Set through current Scarlet and Violet era). Thicker cards, such as jumbo promos or some limited edition oversized releases, need a wider toploader. Our toploader thickness guide covers which thickness fits which card type.
Avoid card sleeves alone when measuring: sleeves add approximately 0.05–0.1 mm per side, which is small but enough to skew a borderline PSA 10 measurement if you calculate the borders without accounting for the sleeve wall.
How to read borderline results
A card measuring 54.5/45.5 on the front is technically inside PSA 10 tolerance, but PSA grades holistically. A result that falls exactly at the threshold often grades as PSA 9 because graders also factor surface condition, edges and corners into the final call. Treat 55/45 as the theoretical ceiling, not a guarantee.
The useful working rule: aim for 53/47 or better on the front before submitting for PSA 10. Cards measuring 56/44 to 60/40 on the front are realistic PSA 9 targets if the rest of the card is clean. Anything worse than 60/40 front will typically land at PSA 8 or lower regardless of surface condition.
Red flags when buying a raw card to grade
When buying raw cards with the intent to submit for grading, centering issues show up clearly in listing photos if you know what to look for. Zoom in on the card's borders. Uneven white space on any axis is visible from a standard product photo.
Avoid any raw listing where the seller's photo shows the card at an angle. Angled shots are the most common way to obscure poor centering. A front-on, well-lit photo is the minimum you should accept for a card you plan to grade.
Holo cards can appear differently centered when the foil is at an angle to the light source. Always evaluate the borders, not the artwork placement.
See our guide on Card Saver 1 vs toploader for PSA submissions for the right holder to use once a card passes your centering check.
If you already bought a card with borderline centering
Your options depend on how far off-center the card is. Cards between 55/45 and 60/40 on the front are still worth submitting: they are likely PSA 9 results if the surface and corners are clean, and a PSA 9 on a valuable card still carries significant premiums over raw.
Cards worse than 65/35 on the front have limited grading upside. Unless the card itself is extremely rare or vintage where even PSA 7–8 slabs trade at premium, the submission cost typically exceeds the grade bump in value. Hold it raw, sleeve and topload it properly, and use it as a display copy.
If you want graded cards without the submission process, independent shops on DexHaul list PSA and CGC slabs across modern sets. See our side-loading vs top-loading card holder comparison if you are still deciding how to store raw cards while you assess them.
Checking centering as a Q4 gift for a Pokémon card collector
A digital caliper and a 200-count toploader pack make a practical and well-received gift for anyone who submits cards to PSA or CGC. The total cost lands under $60, well inside the collector gift range. Browse the DexHaul holiday Pokémon gift guide for more Q4 ideas across all budgets.
Frequently asked questions
What centering does a Pokémon card need for PSA 10?
PSA 10 Gem Mint requires front centering of approximately 55/45 or better, and back centering of 75/25 or better, according to PSA's published grading standards. Both axes (left/right and top/bottom) are measured independently.
What is the centering requirement for PSA 9?
PSA 9 Mint allows front centering up to 60/40. The back threshold loosens significantly to 90/10, meaning back centering almost never disqualifies a card from PSA 9 on its own.
How is Pokémon card centering measured?
Measure the left and right borders in millimeters, then divide the wider measurement by the total of both to get the larger percentage. Repeat for top and bottom. The result is expressed as a ratio like 54/46, where the first number is the wider border's share of the total margin.
Does CGC use the same centering standards as PSA?
CGC uses comparable centering thresholds but applies them through its own grading methodology. Check CGC's current grading scale before submitting, as specific tolerances can differ from PSA at each grade level.
Can a card pass the centering check but still miss PSA 10?
PSA grades holistically, so yes. A card inside the 55/45 centering threshold can still receive PSA 9 if the surface has light scratches, corners show wear, or edges have chips.
Centering is one of four graded attributes: surface, corners, edges and centering all contribute to the final grade.
DexHaul is independent and not affiliated with PSA, CGC, or The Pokémon Company. Browse PSA and CGC graded Pokémon cards from independent shops on DexHaul to see what already-graded cards look like across grade levels before you submit your own.
Catch 'em all
Graded Pokémon cards from independent shops, all in one place.